Our products are easy to install. Watch this.

Part 1. Assemble the cover

Four steps. The sequence matters, so do not skip ahead.

1. 1

   Identify your panels

   Lay all 4 panels out on a clean, flat surface. The large pattern panel is your Front, the two smaller pattern panels are your Left and Right sides, and the small solid panel is the Top.

2. 2

   Orient the panels correctly

   Lay each panel face down on a clean, flat surface, with the decorative (wrapped) side facing down. You will bend inward, away from the face. Never bend toward the face.

   ImportantAlways bend fold lines inward, away from the decorative face. Bending toward the face will permanently damage the panel surface and the pattern.

3. 3

   Bend the panels up

   Using the pre-scored fold lines, bend all 4 panels upward into their 3D shape. Work on one panel at a time and apply firm, even pressure along the full fold line for a clean, square corner.

   TipTake your time with each corner. A crisp, square corner makes riveting much easier and gives a cleaner finished result.

4. 4

   Join the panels with pop rivets

   Align the pre-drilled holes at each corner joint. Feed a pop rivet through each hole and secure it firmly with the rivet gun. Work your way consistently around all the joints until the box is fully assembled.

   TipStart at one corner and rivet your way around in sequence. This keeps the structure square while you work.

Part 2. Fix it to the wall

Five more steps and your cover is up.

1. 5

   Mark your fixing points

   Hold the assembled cover against the wall, in position over the air conditioner. Use a pencil to mark the screw hole positions on the wall through the fixing slots on the panel.

   TipUse a spirit level when positioning the cover so your marks, and the final hang, are perfectly level.

2. 6

   Drill the holes

   Fit your drill with a masonry bit sized for your wall plugs. Drill a hole at each marked point. Blow or brush the dust out of each hole before the next step.

3. 7

   Insert the wall plugs

   Press a wall plug firmly into each drilled hole until it sits flush with the wall surface. Tap gently with a hammer if needed.

4. 8

   Drive in the screws

   Drive a screw into each wall plug, leaving the screw head slightly proud of the wall surface. You want just enough for the cover slots to hook onto securely.

5. 9

   Hang the cover

   Hook the cover over the protruding screw heads by lining the fixing slots up with each screw. The cover should sit flush and feel stable against the wall.